1-20 of 27 results  for:

  • Native American Music x
  • Aerophones (Blown Instruments) x
Clear all

Article

Term used by the Navajo people of the southwestern USA for a whistle.

Article

J. Richard Haefer

End-blown flute of the Flathead Indians of Montana, USA. Often called a courting flute, it is made from elderberry or fir and is about 45 cm long and 2 cm in diameter. The soft elderberry pith is burnt out with a heated metal rod and six ...

Article

Chad Stephen Hamill

End-blown flute of the Native Americans of the Columbia Plateau. It is called č ɫx̣ ʷálq ʷ by the Interior Salish and sepú ‧nme ʔs mít ʼip by the Sahaptin. A heated metal rod is used to push the pith out of a straight section of elderberry stalk 38 to 60 cm long and about 2.5 cm in diameter, and to burn fingerholes (typically six) into the stalk; often an additional non-fingered hole is made near the bottom. A V-shaped slot is cut near the proximal end and partially filled with pine pitch to deflect the air; the slot is covered with a rawhide block to direct the wind over the pitch and against the lower end of the V. Historically it was used by men to court women; nowadays it is more commonly used for personal enjoyment....

Article

Kay Edwards

(b Madison, WI, June 4, 1959). American composer and flutist of Mohican descent (enrolled member of Stockbridge Band of Mohican Nation). He earned degrees in music composition from Northern Illinois University (BM 1981) and Arizona State University (MM 1990) and a separate degree in American Indian Religious Studies from Arizona State University (MA ...

Article

John M. Schechter and J. Richard Haefer

In modern Nahutl, a generic term for an Aztec flute. Traditionally it was a ceramic globular vessel flute. Stanford equates it with the flute çoçoloctli. Clay huilacapitztli have been found up to 20 cm in diameter and with five to eight tone holes. More developed examples are found throughout Central America. It was played together with the ...

Article

Mary Riemer-Weller

Vertical whistle of the Haudenosaunee or Iroquois Confederation people of north-eastern North America. It is made of cane, about 45 cm long with an external duct, like the courting flute, but no fingerholes. Only two notes are produced, the fundamental and its overblown octave. It is used only during the ceremony of the Little Water Medicine Society and in the Eagle Dance, a curing ritual....

Article

John-Carlos Perea

(b Tama, IA, May 13, 1933; d Ames, IA, Aug 16, 2006). Native American (Meskwaki) singer, drummer, and flute player. Kapayou was born on the Meskwaki Indian Settlement in Tama, Iowa, where his mother Lucille, a flute player, taught him sacred and secular repertoires of Meskwaki music. While serving in the Army and working in construction, Kapayou retained his commitment to these traditions. He received a National Heritage Fellowship from the NEA in ...

Article

Leli  

Richard Keeling

Bone whistle of the Maidu and other native peoples of northern California. It is made from the leg bone of a large bird, a deer or other animal, or local cane. The whistles, from 12 to 20 cm long and 1.5 to 2 cm in diameter (the larger of cane), are usually played in pairs, hence the Kato name ...

Article

John M. Schechter and J. Richard Haefer

Notched flute, a large kena, of the Bolivian Alti Plano, also found in Tarapacá Province, Chile. Called pheta by the Chipaya people, it is made from tokoró, a local cane, with six fingerholes and a thumbhole. The instruments are played in groups to accompany dancing, particularly at the feast of Santiago (July 25) among the Chipaya of the Department of Oruro. The ...

Article

Klisala Harrison

Terms for whistles and reed instruments of First Nations peoples of the North American Pacific Northwest, including the Kwakwa̲ka̲’wakw (ma̲dzis), Haida (kingáan), Nuuchahnulth, Tlingit, Tsimshian (hat’awt’isk), and Coast Salish. The instruments appear with and without fingerholes and can be blown by mouth or mechanically. The mouth-blown whistles appear in three forms: stopped pipes, half-stopped pipes, and open pipes. Some older literature and museum catalogues use the term ...

Article

Paula Conlon

(b Fletcher, OK, July 3, 1932; d Lawton, OK, March 5, 1996). Native American (Comanche) maker and player of juniper flutes. He attended the Fort Sill Indian School and Haskell Indian Institute. He learned flute making from the Kiowa maker Belo Cozad (...

Article

Niçude  

Mary Riemer-Weller

Bone whistle of the Omaha Indians of the central Plains of the USA. It is made from the wing bone of an eagle and is about 15 cm long, and it has a V-shaped flue opening in the centre but no fingerholes. It produces only one shrill note which, when played repeatedly, was said to imitate an eagle’s call. The whistle was played during parts of the ...

Article

Chad Stephen Hamill

Whistle of the Salish Indians of the Columbia Plateau. 10 to 15 cm long, it can be made from various hollow dry creek weeds, cow parsnip stalk, willow or elder wood, the ulna bone of a bald eagle, or the leg or wing bone of a crane or similar wading bird. The proximal end is cut at a 45-degree angle to rest against the lower lip of the player. A wedge-shaped hole is cut on the side opposite the angled cut and partially filled with pine pitch to direct the air to the lower edge of the cut. It produces a single sound. Whistles are used by young boys and men for personal enjoyment. The term ...

Article

Richard Moyle

Nose flute of Hawaii. It is a tube of thin-walled native Hawaiian bamboo, traditionally between 25 and 50 cm long, with a nose hole cut at an angle below the upper end, closed by a node. Two or three fingerholes penetrate the tube towards the open end. The traditional way of playing the flute was to hold it with the right thumb and forefinger and use the rest of the fingers of the same hand to cover the holes. The left thumb was used to hold the left nostril closed with the left hand cupped over or under the flute. Like the ...

Article

J. Richard Haefer

Generic term for Anglo instruments used by the Tohono O’odham (Papago) Indians of Southern Arizona and Northern Sonora, Mexico. Piastakuḍ (‘fiesta thing’) refers to those instruments used to perform waila (social dance music; from the Spanish bailar, called ‘chicken scratch’ by Anglos) and pascola dance tunes. They include the ...

Article

Mary Riemer-Weller, Susan M. Taffe Reed and Glen Jacobs

Generic term for an ‘object that is blown into’, used by the Munsee Indians of the Eastern Woodlands in North America; their relatives the Unami use the word ahpikòn. Known historically as the Lenape or Delaware Indians, the Unami and Munsee have bone flutes (...

Article

J. Richard Haefer

End-blown courting flute of the Nez Percé (Sahaptian) people of Idaho. It is made from an elderberry stalk about 35 to 40 cm long and 3 to 4 cm in diameter, with the pith removed. There are six fingerholes plus a seventh hole said to make the sound ‘sweeter’ and also to relate the instrument to the seven-drum religion. A plug made from pitch is placed inside an opening near the proximal end. The opening is covered with a wooden block tied on with animal hide and long hair wraps; the block forms an external duct and symbolizes the wedding of a couple resulting from the playing of the flute....

Article

J. Richard Haefer

Bone whistle of the Flathead Indians of Montana, USA. It is made from a wing or leg bone of an eagle or other large bird and has no fingerholes. It is used for signalling and is associated with personal songs, guardian spirits songs, and sun dance songs. Duct flutes (...

Article

Mary Riemer-Weller

Large wooden courting flute of the Sioux Indians of the northern Plains area of the USA. The name is derived from sĭyo (‘prairie chicken’) and tanka (‘great’ or ‘large’). This flute typifies a wide variety of such instruments used by native peoples throughout the USA and Canada, including among others the Iroquois ...

Article

Double-reed aerophone of the Haida and other peoples of British Columbia. In some types the massive blades of the reed are inserted in the narrow end of a conical wooden (typically cedar) tube and fully enclosed by a large tapered cap, into which the player blows. In other types the reed is exposed. The name is also applied to wooden whistles of British Columbia, sometimes also called ‘dance whistles’; the tapered body is halved lengthwise, hollowed, and carved to form the windway, and reassembled with pitch and twine or split spruce root binding....