Creation of new connections inside sound-generating electronic devices to provide sounds unintended by their original designers. A wide range of effects can be achieved, and extra tactile controls such as potentiometers, switches, photocells, and body contacts can be added to control the new effects, the most frequent modification being for pitch control. Often various ‘bends’ are found accidentally by arbitrarily connecting two different points on the circuit board. Circuit bending has attracted considerable attention among persons interested in experimental electronic music and synthesizers, and it can be achieved with limited electronics knowledge and construction skills. Because circuit bending calls for unauthorised, sometimes radical changes to the circuitry’s original pathways, it risks damaging or destroying the device being modified. Toys are often exploited for circuit bending because of their ubiquity and low cost and the small risk of electrical shock from their low voltage. Battery-operated toys such as the Texas Instruments Speak n’ Spell and the Casio SK-1 have latent sonic potential and are prime targets for tinkerers seeking such sounds inexpensively or at no cost and because they tend to ‘glitch’ easily, spewing out fragmented bits of digital speech and strange sounds. Examples of circuit-bent creations include electronic keyboards, sound modules, drum machines, effects pedals, and karaoke machines. Video bending uses these same methods to modify video-game consoles to make abstract visual patterns in addition to novel sounds....
(Lat.: ‘high [part] against the tenor’)
A line in polyphony lying just above the tenor. In the 15th century, as music came to be written in four rather than only three voices, composers approached the addition of the fourth voice by an extension of earlier compositional procedure. The most common arrangement of three voices had been superius (or cantus), tenor and Contratenor; in the new four-voice texture the composer used two contratenor parts, a contratenor bassus and a contratenor altus. The original method of writing these two voice parts is still evident in Pietro Aaron’s Il Thoscanello de la musica (1523), where ten rules set out ‘the method of composing the controbasso and the controalto, after the tenor and canto’ (bk 2, chap.21). In Italy ‘contratenorbassus’ was abbreviated to ‘bassus’, ‘controbasso’ or ‘basso’; ‘contratenor altus’ became ‘altus’, ‘controalto’, ‘contr’alto’, ‘contralto’ or ‘alto’. In France the term became Haute-contre. English usage was complicated because even in the late 16th century (by which time the word ‘contratenor’ had long been obsolete on the Continent) an alto part might also be called a meane, a contra, a counter or a ...
Originally, a poem in which the passing of an individual is announced and communities to which the departed belongs are called to mourn.
Pioneered by French poets in aristocratic service, the déploration qua literary genre enjoyed a modest lifespan, with eight known works surviving from the 16th century. Longstanding custom, however, recognizes a musical tradition by the same name, one numbering 30 known compositions spanning the late 14th to late 16th centuries. Among composers the déploration ramified from a French mainstream into Spanish, Netherlandish, German, Italian, and English tributaries. Accordingly, déplorations are variably designated in sources by such terms as apotheosis, epicedion, monodia, epitaphium, lamentation, complainte, naenia, madrigale, greghesca, and elegy.
Use of the term “déploration” to denote a musical work in which a composer is commemorated may be traced to Ockeghem (d 1497). This musician, who spent almost a half-century in service to the French royal court, was memorialized by literary counterpart Guillaume Crétin in a poem of 412 lines. A frame-narrative necrology featuring a syncretic cast of characters (among them Orpheus and King David), Crétin’s déploration charges all who held Ockeghem dear with the duty of honoring “celluy qui”—according to Lady Music (another ...
Stephen E. Hefling
Rhythms in which long notes alternate with one or more short notes, so called because the long notes are usually written with the aid of the dot of addition (see Note values). Dotted rhythms are found in mensurally notated music of all periods; this article, however, deals mainly with music of the 17th and 18th centuries, in which it was customary to alter certain sorts of written rhythmic values in performance (see also Notes inégales; for notational meanings of the dot before 1600 see Notation, §III). The principal issue is the degree to which such rhythms sounded uneven, rather than the specific manner of their notation (e.g. the dot may be replaced by a rest or tie).
Dozens of contemporary theoretical and pedagogical sources indicate that the dot was ordinarily equal to one half the value of the note or rest preceding it, just as it is today. But the treatises also present various exceptions. The dot could stand for a tie (...
Murray Campbell and Mary Térey-Smith
The repetition of sound after a short time interval. In addition to the applications discussed below the term is used for a signal-processing device (also known as a delay) that produces a slightly delayed playback of sounds either by a tape loop or by digital delay; see Electric guitar §2 .
See also Organ stop .
Natural echoes arise from the reflection of a sound wave by a solid surface, such as a wall or cliff. For the echo to be perceived as distinct from the original sound, the extra path length travelled by the reflected sound wave must have a minimum value of around 17 metres, corresponding to a minimum time interval of 50 milliseconds between direct and reflected sounds.
The reverberant sound field in a concert hall is created by multiple reflections of sound waves. In a well-designed hall, the direct sound reaching a member of the audience is followed by a series of reflections within a time interval of around 35 milliseconds. These ‘early delayed arrivals’ are not heard as separate echoes; because of the ‘precedence effect’ they are perceived as a reinforcement of the direct sound. Subsequent reflections blend smoothly into the reverberation. A concave surface, focussing sound waves into a particular part of the hall, can give rise to an audible echo; a ‘flutter echo’ can arise from successive reflections between parallel walls....
revised by Anne Beetem Acker
[Elektronmusikstudion] (Swed.: ‘electronic music studio’)
The Swedish national centre for electronic music and sound art, in Stockholm. It was preceded by a smaller studio run by the Worker’s Society of Education from 1960. EMS was established by Swedish Radio in 1964 under music director and composer Karl Birger Blomdahl (1916–68), who hired the composer and performer Knut Wiggen (b 1927) to take charge of creating the studios. In 1965 an old radio theatre studio called the klangverstan (‘sound workshop’) opened for composers. Construction of a new facility was begun, but after Blomdahl’s death EMS became independent, funded only in small part by Swedish Radio, and otherwise by Fylkingen (a society for experimental music and arts) and the Swedish Royal Academy of Music.
Wiggen envisioned EMS as both a place to produce electro-acoustic music and a research institution that would give the composer ‘the possibility of describing sounds in psychological terms’. The studio was equipped accordingly. The sound sculpture ...
Jason Freeman and Frank Clark
Interdisciplinary research centre for music, computing, engineering, design, and business, founded in 2008 at the Georgia Institute of Technology in Atlanta. The Center focuses on the development and deployment of transformative musical technologies, and emphasizes the impact of music technology research on scholarship, industry, and culture. In 2012 the Center had 23 faculty members.
Numerous projects have involved the development of new musical instruments, particularly mobile instruments for smartphone devices; robotic musicians that can listen to and collaborate with human performers; and novel instruments and interfaces designed for health and educational applications. GTCMT research projects have received many grants, mostly from the National Science Foundation. Two spinoff companies, ZooZ Mobile and Khush, have commercialized research results to produce mobile music creation applications.
Though the GTCMT does not have a direct educational mission, it collaborates closely with the university’s School of Music, and several of its faculty members teach courses and advise students in Georgia Tech’s Master of Science and Ph.D. programmes in music technology. The GTCMT presents concerts featuring new instruments, and related events, notably the annual Margaret Guthman Musical Instrument Competition, co-sponsored since ...
Duct flute of Tibet. The term is used for all aerophones of the flute type throughout areas of Tibetan cultural influence; many are made of bamboo, some of wood (e.g. apricot) and brass. The transverse instruments (phred-gling, ti-gling), known in Bhutan as zur-lim, usually have six or seven fingerholes; they are used in secular music and resemble the Indian ...